On this page are some sound and movie files to test the SA UltraCode in pd-mode (Proximity Detection mode) and ls-mode (Light Show mode).

The sound files can be played on any mobile or stationary device.

Important: because most sound files played on this page are inaudible, it's best to set the volume of your loudspeakers with the help of the test file below, so you can set the correct volume. Normal listen level should be fine, no need to play at high levels of SPL.

Please start the StageTools app on your device, and follow the instructions below:

pd-mode

The pd-mode is automatically enabled when your mobile device is showing the "SPL Calculator".

To test the pd-mode just click on the "Start" phone picture on this page.

After a few moments a pop-up will show up with a welcome message.

The leaving message will also pop-up after 15 seconds.

(the welcome and leaving pop-up will show up only once, to test again in pd-mode simply switch to ls-mode and back)

ls-mode

For ls-mode you must switch to the "Light Show" screen on your mobile device and tap the SA greyed-out logo, it glows when it is activated, your device is now "Wating for data...".

To test click on the phone pictures below.
The same screen you select on this page should be showing up on your mobile device.

Below some movies with the SA UltraCode embedded in the sound track.
StageTools must be in ls-mode (and SA logo activated) to react on the embedded UltraCode.